Installing/Replacing an Ink Refill into the Pen

To insert a new refill,

1. Slide the new refill into the tip of the pen. 

2. Gently press the new refill until it is lodged securely in place.

NOTE: Make sure you use a refill that is similar to the original (standard refill (67.0mm long X 2.35mm diameter).

To replace the ink refill,

1. Detach the cap from the digital pen.

2. Clamp the ink refill with the refill extractor. Hold the pen firmly, and apply pressure with the extractor against it.

3. Pull the used refill out.

Installing/Replacing Pen Batteries

(1) Remove the battery compartment cover.

(2) Install two SR41 batteries, with the positive poles facing up.

(3) Supplied batteries are good for initial use only Replace battery compartment cover.

Note:

-  Please use the enclosed GP SR41 batteries with the positive polarity facing up.

- Batteries may be safely disposed of in normal household waste. Contact your local government for disposal or recycling practices in your area

- Caution: Risk of explosion if battery is replaced by an incorrect type Please use silver oxide button cells battery type only.

- Lifetime of the batteries may vary and cannot be guaranteed.

- When your Pen battery runs low, the following message appears on your screen:

This warning is continuously displayed on each new note and the application tray icon in the system tray changes to reflect the current status until the batteries are replaced.

Tray icon indiocation, for Pen low battery, in Note Mode

Tray icon indiocation, for Pen low battery, in Mouse Mode.

Lifetime of the batteries may vary and cannot be guaranteed.

Write Correctly

When you pick up the pen, find a position that is convenient for you. Be careful to hold the pen in a way that does not block the signals sent from the tip of the pen to the memory unit receivers.

When you are writing with the pen, make sure its inclination to the paper surface is between 45°and 90°.

Hold the pen firmly and write normally.

Note: Make sure the pen point is 1.5cm away from the unit. Otherwise, the unit sensor may not work.

WARNING:

Do not attempt to open the pen. This may cause the pen to malfunction.